Also make sure the body panels gap are evenly spaced. Their job is to repaired the to precolision condition. loosen the bolts that can be seen on the inner rear section of the wheel well and under the Toyota vehicle where. Primed Front Bumper Cover Fascia for 2012-2015 Toyota Prius 5211947934 TO1000394 (Fits: Toyota Prius). Its the best place to see if color match is right on or close enough to your sastisfaction. Fit 2010-2012 Toyota Prius Front Bumper Tow Hook Eye Cap Cover Left & Right Pair (Fits: Toyota Prius) 10.72. When the repairs are done make sure to pick it up in the day time. You have the right to because it's still a relatively new car. Say no to recondition or used parts because it's a safety device.Īlso demand all new parts. Then you tell them that is a safety issue and you are uncomfortable. If the insurance bs and say it's not necessary. Just make sure the support bar is replace too with a new Toyota OEM part and that you get to see the old damage one after the repaired.
Just think how much force it takes to bend that support bar and the force to move your car in order for you to feel it. Make sure the shop use a computerize system and can print out the report. Unnecessary as it might sound but something might be moved without you knowing until you go get a wheel alignment and it's never in specs. It's a bit sorry looking, but holding together.Have the shop lift the car up and do a frame measurement check. I've done that a couple of times with ours now. And if you've got minor abrading, 2-part epoxy, maybe with fiberglass mesh reinforcement, can sometimes restore it. It's a bit of a pain, and once in a while you forget, but just minimizing the times this happens will help. The ongoing solution, avoid getting too deep into parking spots. Front Bumper Tow Hook Eye Cover Cap for Toyota Prius C 2012-2017 Front. Maybe if the panel itself has to be replaced: order that through amazon, and for fasteners use the dealership? Up to you. Read the quality reviews left by other shoppers to make an informed decision.
#FRONT LEFT WHEEL BUMPR COVER 2012 PRIUS DRIVER#
Throw down some sort of mat if you're parked on loose earth, and with a screw driver (for the plastic fastener) and a ratchet wrench (with extension and 10 mm socket) you can have that thing off in 5 minutes.Īny dealership parts department is the most direct route to replacement parts, albeit more pricey. You do need to lie down in front, to see what you're doing. The good news: you can remove, repair and/or replace this without the need to raise the car. As long as you're not looking under there yourself, relying on "pros" to "repair" it with baling wire, it'll be an ongoing problem. There's also one plastic fastener, a somewhat odd one, at the front/centre.ĭutch Uncle time: you need to get involved, look it over carefully, understand what's going on. The metal screws are coarse thread, screw into nylon blocks pushed into the trailing edge of the painted bumper. There's a mix of metal screws and metal bolts.
You've got to get down there, remove it, see what's happening. Then when you back the car out it snags, kinda like a barbed hook, and really abrades and tears itself. The latter in particular are tough on it: you pull into a parallel parking spot, and that piece rides up and over the wheel stop. The likely reason it's falling off (assuming it's the first black plastic underpanel, just aft of the painted bumper): it's not quite high enough off the ground to clear a lot of curbs and concrete wheel stops.
0 kommentar(er)
